Golden Paintworks - Pintura para murales y temas - Colores estándar

• Strong, opaque, vibrant colors
• Ready to use
• Thins easily for more transparent colors
• Exterior colorants selected for advanced lightfast qualities
• Single component, 100% acrylic waterborne formulation
• < 50 g/l VOC content. Complies with VOC regulations in all US jurisdictions
• Meets the criteria for LEED Credit 4.2 (Low Emitting Materials – Paints and Coatings)
• Water clean up

Golden Paintworks Mural & Theme Paints may be applied to most surfaces suitable for exterior latex paint, including drywall, wood, masonry, plastics and metal if these substrates are cleaned, prepared, and primed. Follow industry standard practices and procedures for preparing surfaces for the application of water-based architectural acrylic coatings.

Remove all surface contamination by washing with an appropriate cleaner, rinse thoroughly and allow to dry. Existing peeled or cracked paint should be scraped and sanded to a smooth, sound surface (See warning below). Stains from water, smoke, ink, pencil, grease, etc. should be sealed with the appropriate primer/sealer.

• Stir contents before use.
• Brush, roller or spray apply.
• Apply when the substrate and ambient air temperature is between 50°F & 90°F. Ideal range is 65°F & 75°F.
• Ready to use; may be thinned with water for more transparent effects.
• May be thinned with water, up to 10:1 (10 parts water to 1 part paint) for color washes.
• A protective clear coating is recommended for dilutions greater than 1:1 or any exterior application.
• For exterior or interior use, unless specifically noted as interior only.
• Allow 1-2 hours drying time between coats.
• Testing your process and technique before applying is recommended.

Brush: A high-quality nylon/polyester brush is suggested.

Roller: Use a high quality 3/8” - 3/4" nap synthetic cover.

Spray equipment:
AIRLESS
No thinning is required, but product may be reduced with water
as desired.
• GRACO Mark V: 2,400 – 2,600 PSI. 517 or 515 tip.
• Titan 44i, Latex (high) tip.
HVLP/Cup Gun:
Reduce 20% - 40% with water to adjust for proper atomization.
• Titan TS 40P, 17/000 tip
• Vapor 1900,1.4 mm tip, 40 psi
When spraying, wear eye protection and particulate respirator.

Highly dependent on application technique and number of layers. Approx. 300-400 sq. ft. / gal.

@ 50% RH, 77°F: Touch 30 minutes. Recoat 1-2 hours.
• Air movement and exchange will assist in proper drying.
• Cold weather & high humidity will slow down cure time.
• A drying time of 12 – 24 hours is recommended before the application of
protective clear coatings.

Clean your skin and equipment immediately after use with soap and warm water. Dispose of as latex paint.