Golden Paintworks - Esteatita

• Can be colored with flat paint or tinted with universal colorants.
• Great for dimensional effects to smooth plaster finishes
• Water clean up
• VOC Compliant

Surface must be clean, dry and free of dirt, oil, wax and grease. Remove any loose, flaking or chalking paint from the surface. Do not apply to slick or glossy surfaces. Prime surface with an appropriate, high-quality, water base primer and allow to fully dry.

Prepare drywall by filling cracks and holes with patching paste/spackle and sand smooth. Joint compounds must be cured and sanded smooth. Remove all sanding dust. Prime with 2 coats quality acrylic primer. Note: For a smooth polished look, it
is recommended that all wall surfaces be prepared to a Level 5 properly painted surface as specified by GA-214 and PDCA P5-94.

• Stir contents before use.
• Trowel, brush, roller or spray apply.
• Apply at temperatures between 50° F & 90° F.
• May be thinned with water, up to 30% by volume.
• May be colored with pre-tinted flat acrylic paints. Up to 25% addition by volume will not affect application properties.
• May be tinted with waterborne or Universal colorants (UTC), up to 10% by volume.
• Allow a minimum of 1 to 4 hours drying time between coats.
• Test your technique on a practice board before applying to walls.
• For indoor use

Spray Application allows for a consistent, uniform amount of product to be applied rapidly for a quick follow up knock down. When spraying, wear eye protection and particulate respirator, and prevent others from coming into contact with spray mist.

Spray equipment options:
Hopper Sprayer:
• Marshalltown SharpShooter® or equivalent
• #1 tip (3/16” / 5 mm orifice); 40 PSI
• No reduction required, but may be reduced up to 30% to adjust application properties.

Pump/compressed air sprayers with reservoir:
• Best Recommendation: Graco® TexSpray RTX 1500 or equivalent
• “White” tip; ”high” air volume setting
• Reduce 10% - 15% with water when using line feed from stationary hopper.

Medium Stainless Steel Plaster Trowel (240 x 100)
3” Spatula
Fine Sanding Sponge

Highly dependent on application technique and number of layers. Approx. 50-150 sq. ft. /gal.

@ 50% RH, 77° F: Touch 1 hour. Recoat 4 hours. Cold weather & high humidity will slow down cure time.

Clean your skin and equipment immediately after use with soap and warm water. Consult with local authorities for methods of disposal.