Ronan - Vinyl Cote


Un recubrimiento acrílico transparente a base de agua formulado para usarse como capa superior protectora sobre vinilo sin tratar, letreros de vinilo pintados, letras de vinilo, pancartas, toldos de vinilo, boletines y muchos otros sustratos.

Choose your location

enter a US zip code

Más información

Especificación del producto

Vinyl Cote UV Absorber is specially formulated to provide extra ultraviolet protection. It is designed for use as a topcoat where resistance to the effects of exposure to sunlight and weather is a requirement. It helps prevent color degradation by reducing the harmful effects of ultraviolet rays, which cause premature fading. It is ideal for use over fluorescent colors to prolong color retention. Do not use over Gold Leaf. Can be applied as a protective overcoat on vinyl signs without the problems associated with solvent based ultraviolet absorber topcoats. Can be used wherever a water based, non-yellowing, weather and ultraviolet resistant coating is required. Non-Flammable, low odor. Available in flat, satin or gloss. 

SURFACE PREPARATION

All surfaces must be clean, dry and free from loose or peeling paint, grease, oil, dirt, rust, mill scale and other contaminants. Refer to technical data sheet for more information on surface preparation. Pretreat vinyl surfaces by wiping with isopropyl alcohol, then allow to fully dry before applying Vinyl Cote. Note: Because there are many different types of vinyl, it is always recommended that Vinyl Cote be tested for compatibility before using. To test, apply Vinyl Cote to a small section, then let dry fully (8 hours). Apply a piece of tape to the coated area, then remove. Coating should not lift with tape.

APPLICATION

Stir contents thoroughly. Do not thin under normal conditions. Use at full strength for maximum efficiency. Do not apply in heavy wet coats. Do not allow wet film to puddle. for best results, apply two (2) to three (3) thin coats. Allow each coat to dry thoroughly before applying the next.

Brush: With any good quality synthetic bristle brush.

Roll: A short nap industrial roller will give best results. Do not use a foam roller.

Spray: This product can be spray applied with equipment intended for waterborne finishes. Refer to spray equipment manufacturer's instructions.

Do not apply under 60°F or above 95°F, or if humidity is higher than 90%. For more information on application methods, refer to technical data sheet.