Scofield - SelectSeal Plus

Distribute product with a pump garden sprayer fitted with a conical tip, followed by back rolling with a quality 3/8" knap roller. Roll in multiple directions to ensure
product penetrates into concrete cracks, joints, and pores. Take care not to create lap marks as they cannot be removed once the product has dried. Dried material
will be difficult to remove. Remove overspray immediately with hot water and detergent.

Coverage will depend upon thinning, method of application, surface porosity, and the texture of the substrate. Full strength prime-coat coverage on flat finished concrete is typically 300–400 sq. ft./gal. (7.4–9.8 sq. m/L), and will yield a dry film thickness of 1.3–1.1 mils. Thinned with 1 pint of water per gallon, prime coat coverage is typically 450 sq. ft./gal., and will yield a dry film thickness of 0.85 mils. Porous, broom or textured finishes will require more sealer. As a topcoat or for second coat application, coverage of 600–800 sq. ft./gal. (14.8–19.6 sq. m/L) is typical.

Dry times will depend upon the selected coverage rate, penetration into the substrate, and weather conditions. At 70°F (21°C) and 50 % relative humidity with an application rate of 400 sq. ft. per gallon (10 m2/L), dry to touch and recoat times of 1–2 hours are expected. Avoid foot-traffic for a minimum of 12 hours, and hard wheel traffic for 72 hours after final application.

Clean equipment with warm water and detergent immediately after application.