Axalta - Tufcote Hydro 1294 Black

Surface must be free of oil, grease, dirt, wax, silicone, powdery or scaling rust, loose or peeling paint and all other foreign matter. Smooth slick surfaces should be sanded to promote adhesion. Prime bare and uncoated surfaces with one of the following Tufcote primers: Tufcote Hydro 2.1 PR (1200 waterborne series), Tufcote LV PR (4400 series) or Tufcote Hydro LV PR (7900 waterborne series).

METAL SURFACES:
Aluminum surfaces should be properly treated. Surface preparations may include sanding, brush off blasting (SSPC-SP7), alodine treatment, treatment with an acid, or other preparation necessary to ensure adhesion. All aluminums are not alike, it is strongly suggested that adhesion testing be done to assure system robustness.

Galvanized steel surface preparation may include detergent washing, pre-treatment and abrasion for new surfaces; for weathered surfaces, detergent washing and sanding. For new galvanized surfaces, acid treatments, degreasing and abrasion might be required before application of appropriate primer.

PAINTED SURFACES: Be sure all loose and peeling paint is completely removed, and the surface is clean. Remove excess chalkiness with a wire brush or by sanding. Feather edge and spot prime with Tufcote Primer.

WOOD SURFACES: Clean wood thoroughly. Prime and seal with one coat of Tufcote Primer or Tufcote Hydro (tinted close to finish color, if desired).

Apply 2 coats, 1 to 2 hours apart, if possible, using conventional application methods and equipment.

Cure Time at Recommended Thickness @ 50% RH 77°F (25°C)

• To Touch - 30 minutes
• To Handle - 1-2 hours
• Recoat Time - 1-2 hours
• Full Cure - 7 days

Clean pad applicators, brushes and rollers immediately after use with soap and cold water. Clean spray equipment immediately after use with water followed with Tufcote 8020 Zero VOC Exempt Solvent.