Old Masters - Fast Dry Stain

Stir well before and during use. Stain may be brushed, sprayed or wiped onto the
surface. Before the stain dries, wipe off excess stain with a soft cloth. Allow stain to
dry thoroughly before applying topcoat.

Approximately 500 square feet per gallon depending on the porosity and texture of
the wood.

Oil-based finishes may be applied 30 minutes after wiping. Dry times may be extended due to humidity, low temperature, lack of air movement, excess stain application or lack of penetration. Be sure surface is thoroughly dry before top coating. Ideal drying conditions recommended are 70° to 75°F and 35% to 50% humidity.

Using a cleaning solvent, such as paint thinner or mineral spirits, is recommended for clean up.

We recommend Old Masters clear finishes. However, Fast Dry Wood Stain can be
top coated with virtually any finish including professional finishes such as lacquers
and conversion varnishes. Wait 24 hours before top coating with a water-based clear finish.

The wood surface must be clean, dry and free from dirt, wax, or grease. Sand the
wood thoroughly, first with medium grit sandpaper, then progressing to a fine grit
paper. Always sand in the direction of the wood grain. Sand smooth, then remove
dust particles with a lint-free rag or a tack rag. If staining previously finished surfaces, first restore the surface to bare wood by completely removing the old finish, then follow the surface preparation directions listed above.