Rust-Oleum - ROCEpoxy

Remove all dirt, grease, oil, salt, and chemical contaminants by washing the surface with Krud Kutter® PRO Cleaner Degreaser. Mold and mildew must be cleaned with Krud Kutter PRO One Step Cleaner & Disinfectant. Rinse thoroughly with fresh water and allow to fully dry. All surfaces must be dry at time of application.

Airless spray is the preferred method of application. However, brush, roller, or air-atomized spray may also be used. Refer to table available in the technical data sheet for thinning recommendations. For proper performance, a dry film thickness of 5-8 mils per coat is required. Excessive brushing or rolling may reduce film thickness. Apply a second coat if necessary to achieve the recommended film thickness.

100 - 200 sq. ft. per gallon depending on activator.

To touch: 4 - 24 hours depending on activation method, reference technical data sheet.

Recoat: 4 hours - 1 year depending on activation method, reference technical data.

Thinning is normally not required, except for air-atomized spray. For air-atomized spray application, thin only up to 10% by volume with Professional Solutions Xylene Solvent Blend after the components have been mixed. If the coating is going to be used in immersion service, 9102 or 9104 activator, then, use up to 10%
Professional Solutions Water Immersion Reducer for air-atomized spray and up to 5% of Water Immersion Reducer for airless spray.

Use Professional Solutions Xylene Solvent Blend or Water Immersion Reducer.