Smith Paints - CRU'86

• Good Gloss Retention & Light Reflectivity
• High Performance - Improves service life of coating system
• Abrasion Resistant - Very Durable
• Chemical & Stain Resistant
• U.V. Stable, Aliphatic Polyurethane
• Long Working time
• Easy to Clean
• Resistant to Hot Tire Pickup
• Less Odor than Traditional Solvent-based, Moisture-Cured Polyurethanes
• VOC compliant in most regions <99g/L
• Meets FDA & USDA standards for flooring

Thoroughly sand to degloss surface, vacuum then Acetone tack rag clean prior to application of Smith’s CRU’86. Do NOT Use alcohol to clean substrate due to risk of moisture being drawn to the substrate surface from the air.

Note: Methyl Methacrylate (MMA) is NOT a compatible substrate, expect delamination if topcoated.

Additional surface preparation details are available in the technical data sheet.

Smith’s CRU’86 is strictly a finish topcoat product intended for no more than 5 mils and will blister if applied too thick. Any imperfections, sanding marks/swirls, scratches, gouges, etc. that can be felt by hand or catch a finger nail when pulled across the area in the prior layer may transfer through this finish due to the minimal thickness of Smith’s CRU’86 in a single coat application. Surface defeats are purely aesthetic and pose no threat to the long term performance of the coating system.

Additional application information available in the technical date sheet.

Smith’s CRU’86 is intended for thin, topcoats only.

DO NOT APPLY as a Gloss at thicker than 375 sq.ft. per gallon and no less than 425 sq.ft. per mixed gallon (approximately 4 mils wet) in a single layer to avoid fogging, orange peel or CO2 bubbles in the film.

To touch: 3.5 - 4 hours

Recoat: N/A (Sand prior to recoat)