Star Scenic - Glaze Extender (Wetedge)

• Waterborne
• Low odor
• Compatibility with a variety of latex paints
• Non-flammable

All surfaces to be coated must be free of dirt, oils, and any other contaminants
that may prevent proper adhesion. For new concrete, wait 28 days to cure and
apply a high quality acrylic primer, before application of Extender Glaze.

Pretreat all cracks with a non-silicon based high quality acrylic caulking.

Use a good quality detergent and dilute with 1 liter (1/4 gallon) of water and mix
thoroughly. Wash entire surface with detergent solution using a scrubbing brush. Let the soap solution stand for 5 minutes prior to rinsing. Rinse the entire surface twice with clean water, if any dust or powder remains continue rinsing. Allow the surface to dry completely.

Use a good quality synthetic roller, plastic trowel or airless spray to apply an
even coat of Extender Glaze.

NOTE: Film formation of Extender Glaze depends on temperature and humidity. minimum film formation temperature is 10°C (50°F) and maximum relative humidity is 60%. Lower temperature and higher humidity results in longer curing time.

Varies greatly depending on application, for more details reference technical data sheet.

Open time: 35 min.

Recoat: 48 hours

Wash all tools and equipment immediately with warm water and mild detergent.